Question: i need the CLI ACL commands to solve this question the ospf has been made for R1 and R2 with area 0 but I couldn't
i need the CLI ACL commands to solve this question the ospf has been made for R1 and R2 with area 0 but I couldn't make ACL command question I need help



Figure 1: Topology CCC Table 1: Addressing Table (e) Setup ACL on the router interfaces and direction based on the following policies i. Permit packets from S1 going to LAN 1 (2 marks) ii. Deny packets from S2 going to LAN 1 (2 marks) iii. Permit packets from S2 going to LAN2 (2 marks) iv. Deny packets from S1 going to LAN2 (2 marks)
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
