------I need part B using the information from part A ------

ONLY IN MATLAB- ONLY IN MATLAB- ONLY IN MATLAB- ONLY IN MATLAB -ONLY IN MATLAB- ONLY IN MATLAB- ONLY IN MATLAB

1. Rectifier Design (20 points) An engineer designs a power supply that consists of a transformer, a full wave, 4-diode bridge rectifier and smoothing capacitor. She designed the supply to operate in the U.S. where the power line frequency and voltage is 60 Hz and 120 V respectively. The ripple voltage at full load is 20 mv. A. Estimate the ripple voltage when the unmodified supply is used in regions of Turkey where the corresponding values are 50 Hz and 220 V respectively. Assume that the equivalent load resistance stays the same. B. Draw the rectifier circuit on the Simulink/SimScape platform (all the components; transformer, diodes, resistor, capacitor). Simulate the system in both conditions and compare the results. Use only one scope! Hint: V. = 2 2 RC