Question: In a turning process, if the stock diameter D = 2 i n , length of cut L = 1 2 i n , cutting

In a turning process, if the stock diameter D=2in, length of cut L=12in, cutting time Tm=2min, the allowance is 8% of L, and feed rate fr=0.004inrev, can you use a HSS cutting tool which is rated for surface velocity is 200 sfpm?
In a turning process, if the stock diameter D = 2

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

2 0 . 5 ( A ) ( USCS units ) A turning operation is performed using a rake angle of 1 5 . Cutting speed = 2 0 0 f t m i n , feed = 0 . 0 1 2 i n r e v , and depth of cut = 0 . 1 0 0 i n . The chip...

Q:

A 250-mm-wide strip with a thickness of 20 mm is fed through a rolling mill with two powered rolls, each of radius = 200 mm. The work thickness is to be reduced to 17 mm in one pass at a roll speed...

Q:

Problem 4 - Forces in Deep Drawing (Found in Chapter 19) For the drawing operation of Problem 3 (Cup Drawing), the tensile strength of the sheet metal (low-carbon steel) = 300 MPa and yield strength...

Q:

Problem 5 - Machining Time in Turning (Found in Chapter 21) A turning operation is performed on a cylindrical work part whose diameter = 150 mm and length = 500 mm. Cutting speed = 3.0 m/s, feed =...

Q:

A horizonal milling conducted on a mild steel plate of a biomedical device is shown in the right figure. We know that the constant k = 1, cutting speed V=50 ft/min, cutting tool diameter D = 2 in,...

Q:

A turning operation is performed on a cylindrical work part whose diameter = 150 mm and length = 500 mm. Cutting speed = 3.0 m/s, feed = 0.3 mm/rev, and depth of cut = 2 mm. Determine: a. the cutting...

Q:

1. The selection of the manufacturing process is affected by? a) Size and geometry of the product b) Product quantity c) Product material d) (a).(b),de(c) 2. The lathe uses a facing tool in facing...

Q:

1. The selection of the manufacturing process is affected by? a) Size and geometry of the product b) Product quantity c) Product material d) (a).(b),de(c) 2. The lathe uses a facing tool in facing...

Q:

Strategic Leadership Real Life Case Study Assignment (Individual Basis) Purpose of the learning activity: This project will allow the students to use the concepts of Strategic Leadership learned over...

Q:

seventh pages Chapter 3 Curve Sketching How much metal would be required to make a 400-mL soup can? What is the least amount of cardboard needed to build a box that holds 3000 cm3 of cereal? The...

Q:

Markov Manufacturing recently spent $15 million to purchase some equipment used in the manufacture of disk drives. The firm expects that this equipment will have a useful life of five years, and its...

Q:

XYZ School is a national plus school in Indonesia that implements an international curriculum. This school was founded in 2017. Because this school is growing and the number of students is growing...

Q:

Wang Anshi proposed a Green Sprouts Policy that gave subsidized loans to the poor. False True

Q:

Erie Company manufactures a mobile fitness device called the Jogging Mate. The company uses standards to control its costs. The labor standards that have been set for one Jogging Mate are as follows:...