Question: in an orthogonal cutting process, shear plane angle is 3 2 . 6 degree and rake angle of cutter is 1 9 . 3 degrees.

in an orthogonal cutting process, shear plane angle is 32.6 degree and rake angle of cutter is 19.3 degrees. what is the shear strain (the precision is three digits after decial points)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

Question 3 (5 Marks): Turning is performed on a work material with shear strength of 250 MPa. The following conditions are used: v = 3.0 m/s, f = 0.20mm/rev, d = 3.0 mm, and rake angle = 7 in the...

Q:

The following data are available from orthogonal cutting experiments. The depth of cut (feed) to = 0.13 mm, width of cut b 2.5 mm, rake angle a = - 5, and cutting speed V = 2 m/s. Chip thickness, te...

Q:

4. A plane-strain machining operation is modeled as a 2-dimensional orthogonal cutting process. Two different cutting conditions are shown in Figure 1 and Figure 2 in terms of the undeformed and...

Q:

19. Built-Up Edge (BUE) accumulates on a. Flank face b. Rake face c. Side face 20. In orthogonal turning, increasing the positive rake angle, will: a. Reduce forces b. Reduce temperatures c....

Q:

1) 2) 3) 4) In an ideal orthogonal cutting experiment (see figure), cutting velocity V = 1 m/sec, the rake angle of the tool =5, and the shear angle is known to be 45 Applying the orthogonal cutting...

Q:

2) In an ideal orthogonal cutting experiment (see figure), cutting velocity V = 1 m/sec, the rake angle of the tool =5, and the shear angle is known to be 45 Applying the orthogonal cutting model,...

Q:

GL1601-Based on Problem 16-1A LO P1, P2, P3, P4 General Journal -a. Record the purchase of materials (on credit) -b. Record direct materials used in production. -c. Record the usage of indirect...

Q:

Cecconi Company manufactures soccer balls in two sequential processes: Cutting and Stitching. All direct materials enter production at the beginning of the Cutting process. The following information...

Q:

Please answer the following questions Cecconi Company manufactures soccer balls in two sequential processes: Cutting and Stitching. All direct materials enter production at the beginning of the...

Q:

On the profitability side, you should specifically address the following points: a) Is the cost structure of the two companies similar or different? Does the cost structure reflect their respective...

Q:

Solid nickel reacts with aqueous nitric acid (HNO3) to form aqueous nickel (III) nitrate and hydrogen gas. Write out and balance the chemical equation, including phases?

Q:

You have an assignment to appraise a dairy heifer feedlot and discovered one recent sale that is highly comparable to your subject property. The unit of comparison for these types of facilities has...

Q:

1 . Explain the what information is necessary to determine the amount of federal income tax to be withheld from an employee's paycheck. 2 . What is the importance of the wage base limit when...

Q:

please help me and please show your work thank you . Cornwall Mobile Detailing (CMD) is a service that washes and details a customer's vehicle at their home or of?ce. It operates on a membership b...