Question: in cisco What is the command for setting the clock rate on a router s DCE serial interface to 5 6 0 0 0 ?

in cisco What is the command for setting the clock rate on a
routers DCE serial interface to 56000?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!

Q:

What is the solution for this lab with the network application on the cisco packet trcer program LAB 7: Configuration and analysis of dynamic Routing Protocols Part A: Configuration and analysis of...

Q:

Configure and Verify RIPv2 Routing Configure RIPv2 on the routers and verify that it is running. Configure other features of RIPv2 Add static routing for IPv6 for end to end connectivity. Examine...

Q:

What is the command for setting the clock rate on a router s DCE serial interface to 5 6 0 0 0 ?

Q:

IFT 366 TCP/IP & Routing Lab 1 Configuring the router via the CLI (the very basics) Purpose of this lab : get an overview of some of the tasks that are done to configure a typical router. We will use...

Q:

Lab 7 Configuring Static Routes Name: Overview The overall objective of this lab is to configure static routes on two routers so that there is a network connection between the computers in the two...

Q:

Network Addressing St. Louis Serial Port: 192.168.41.17 /30 (Chicago) Ethernet Port: 192.100.44.1 /24 Workstation A: 192.100.44.80 /24 Nashville Serial Port 192.168.81.129 /30 (Chicago) Ethernet...

Q:

Objectives To configure the router. To use the ping, traceroute and show commands to check network connectivity. To understand the RIP protocol. Equipment Two sets of Cisco 1720/1841 routers Two sets...

Q:

In Active Learning Module 1, full connectivity was not achieved. Why is this? When a packet entered a router that was destined for a network (ie: subnet) within the topology that as not local to the...

Q:

Answer all questions thank you. Number of the needed 2000 Number of needed 15 Network address 178, 100.0.0 Based on the above answer the following questions: Total number of Subnets Total number of...

Q:

Part 2: Troubleshoot Layer 3 COHI'IECIIVIW In Part 2, you will verify that Layer 3 connectivity is established on all interfaces. You will need to test both IPv4 and IPv6 connectivity for all device...

Q:

If f(x) = 3x2 - x + 2, find f(2), f(-2), f(a), f(-a), f(a + 1), 2f(a) f(2a), f(a2), [f(a)]2, and f(a + h).

Q:

A study by M. Chen et al. titled "Heat Stress Evaluation and Worker Fatigue in a Steel Plant" (American Industrial Hygiene Association, Vol. 64, pp. 352-359) assessed fatigue in steel-plant workers...

Q:

Consider an investor based in the DC that invests in the FC . To hedge the FX risk the DC investor could ( select all that are true ) : Purchase a put option DC to FC at today's spot FX Engage in a...

Q:

Is Arirbnm a successful start up company? What did Airbnm learn from Covid-19? How is the company pivoting its busiess model to adjust to the new environment and improve the performance of the...