Question: In the write - back stage, where is the data read from? EX / MEM pipeline register IF / ID pipeline register MEM / WB

In the write-back stage, where is the data read from?
EX/MEM pipeline register
IF/ID pipeline register
MEM/WB pipeline register
ID/EX pipeline register
In the write - back stage, where is the data read

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!

Q:

Consider the execution of the following code in this pipeline. lw $t1, 0($t2) #1 add $t1, $t1, $t3 #2 lw $t3, 0($t1) #3 add $t2, $t2, $t3 #4 a)Identify each of the data hazards that cannot be...

Q:

Assume that we have a 5-stage pipeline that has no branch delay slot and no particular branch prediction mechansim employed. Thus, when we have branch instruction, we have to introduce pipeline...

Q:

Assume, we want to execute the following instruction sequence in a 5-stage MIPS pipeline that we discussed in the classroom lw S12, 0(St0) lw St1, 4(St0) add St4, St1,St2 sw St4, 12(St0) lw St3,...

Q:

Please answer both a and b completely and explain your answers. Thank you! For question 3, refer to the pipeline design with forwarding and (load-use) hazard detection, shown below, which supports...

Q:

Write a program using your favorite programming language that reads assembly code like the following: LW $0, $1(20) load instruction at address $1 + 20 and put the result in register $0. ADD $3, $0,...

Q:

Question 2 You are hired by HT 6 4 Systems to implement a new 6 4 - bit processor that has the following pipeline stages: IF Instruction Fetch: First Cycle. RD Instruction decode and register fetch....

Q:

Need help with the D, E, F. C.5 For these problems, we will explore a pipeline for a register-memory architecture. The architecture has two instruction formats: a register-register format and a...

Q:

1. The function L is defined as L(1) = 2,L(2) = 1, L(3) = 3,L(4) = 4 and for n > 4, L(n)+L(n-1)+L(n-2) L(n+1) = L(n-3) i.e., the (n+1)-th value is given by the sum of the n-th, n-1-th and n-2-th...

Q:

1. Type 1a EX data hazard. The forwarding unit will forward ALUResult, which is $t1 - $t2, produced in clock 3 of the sub instruction so that $t1 - $t2 becomes the A input to the ALU for the and...

Q:

1. Type 1a EX data hazard. The forwarding unit will forward ALUResult, which is $t1 - $t2, produced in clock 3 of the sub instruction so that $t1 - $t2 becomes the A input to the ALU for the and...

Q:

An electron is confined in a one-dimensional box of length L. Another electron is confined in a box of length 2 L. Both are in the ground state. What is the ratio of their energies E2L/ EL?

Q:

The mean time taken to design a house plan by 40 architects was found to be 23 hours with a standard deviation of 3.75 hours. a. Construct a 98% confidence interval for the population mean . b....

Q:

Can you explain the process for solving this General accounting question accurately? Brentwood Co. collected the following data related to a mixed cost, using units produced as the activity base:...

Q:

Answer the following questions (a)Rowan has invented a new household device that would earn him $12,000 per annum for the next 10 years. Given an interest rate of 10% compounded annually, would Rowan...