Lab $2$ part $1$

Part $1$: Configure Basic Device SettingsIn Part $1,$ you will set up the network topology and configure basic settings, such as the interface IP addresses, device access, and passwords on the devices.Step $1$: Cable the network as shown in the topology.Attach the devices shown in the topology and cable as necessary.Step $2$: Initialize and reload the router and switch.Step $3$: Configure the router and switch.Open configuration windowa. Console into the device and enable privileged EXEC mode.b$.$ Assign the device name according to the Addressing Table.c$.$ Disable DNS lookup to prevent the router from attempting to translate incorrectly entered commands as though they were hostnames.d$.$ Assign class as the privileged EXEC encrypted password.e$.$ Assign cisco as the console password and enable login$.$f$.$ Assign cisco as the VTY password and enable login$.$g$.$ Create a banner that warns anyone accessing the device that unauthorized access is prohibited.h$.$ Configure and activate the G$0/0/1$ interface on the router using the information contained in the Addressing Table $($For router$)$i$.$ Configure the default SVI on the switch with the IP address information according to the Addressing Table. $($For switch$)$j$.$ Save the running configuration to the startup configuration file.Close configuration windowStep $4$: Configure PC$-$A$.$Open command prompta. Configure PC$-$A with an IP address and subnet mask.b$.$ Configure a default gateway for PC$-$A$.$Close command promptStep $5$: Verify network connectivity.Open configuration windowPing R$1$ and S$1$ from PC$-$A$.$ If any of the pings fail, troubleshoot the connection.Close configuration window