Lab Exercise $7$: Basic Device Configuration with Netmiko

Objective: Connect to a Cisco device using Python and Netmiko, enter enable mode, configure a loopback interface, and save the current configuration.

Instructions

Set Up Connection:

Define the connection details for the Cisco device using the dictionary below, The device should use the following details:Python$2.$ Write the Script:

Write a Python script that:

Connects to the device using Netmiko.

Enters enable mode.

Enters global configuration mode.

Configures a loopback interface $($LoopbackO$)$ with an IP address $(10\mathrm{.}10\mathrm{.}10\mathrm{.}1255\mathrm{.}255\mathrm{.}255\mathrm{.}0).$

Saves the current configuration using save$\_$config$().$