Please answer each screenshot's process capability index and if the process is capable. Then questions E, F & G on the last screenshot

Determine whether each process is capable of producing to specifications Hospital Laundry The laundry department of a large hospital contains energy efficient industrial washing machines for laundering sheets and towels. High energy (HE) laundry detergent is automatically dispensed at the start of each load. If an insufficient amount of detergent is dispensed, the laundry will not be completely cleaned, while too much is unnecessarily costly and can damage the machine's bearings. Determine whether each process is capable of producing to specifications Tea Shop Herb's Tea Garden is a small tea shop specializing in blended loose leaf hot tea. Customers select from a variety of fine loose tea leaves, dried flowers and dried fruits to create their own unique tea blend. Because of the popularity of the tea shop, combined with the custom blending process, waiting times can sometimes be excessive; most customers would prefer to wait less than five minutes. Determine whether each process is capable of producing to specifications Filled Donuts Bob's Bakery carries a wide variety of pastries, including his famous filled donuts. Each donut is injected with a flavored jelly or cream. The customers complain if they feel that there isn't a sufficient amount of filling in their donuts. Overfilled donuts are messy and waste costly filling. Determine whether each process is capable of producing to specifications Tire Pressure One of the tasks on the turnaround list for a rental car agency is to check and adjust tire pressure. When a tire is over-inflated, it can cause a bouncy ride and poor handling. If it is under-inflated, it can cause premature wear due to increased friction. Challenge 3 - See if the process is centered by comparing the Control-Limits' mean to the Specs mean. If it is use Cp to find its Capability index. If not use Cpk. - Process mean is between the UCL \& LCL - Standard deviation (STD) can be found by subtracting the process mean from the UCL and then dividing by 3 (assume n=1 ). See also the Technology Primer at the end of these instructions. - Take a screenshot of each case (A thru D). - Answer: e. "Control limits are calculated while specification limits are set". What does this mean? f. What does it mean when the control limits fall inside the specification limits? Is this good or bad? g. What does it mean when the control limits fall outside the specification limits? Is this good or bad