Question: please do C. do not just do A and B and ignore C. 4. The daily demand for parts made at machining workcell JMB is

please do C. do not just do A and B and ignore C.

4. The daily demand for parts made at machining workcell JMB is 1600 units. The average process- ing time is 25 seconds per unit. A container spends, on average, six hours waiting at JMB before it is processed. Each container holds 250 parts. Currently 10 containers are being used for the part. a. What percent safety margin of stock is being carried? b. If you wanted to retain this safety margin, but remove one container, to what value mus the waiting time be reduced? c. What would happen if the demand for parts increased to 1900 with K=10? 11

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

please answer question C. Q5 20 Marks (a) As a part of lean production and Just-In-Time (JIT) implementation, it requires to minimize the setup time. What are the important steps adopted to reduce...

4. The daily demand for parts from machining workcell JMB to an assembly workcell is 1,600 units. The average processing time is 25 seconds per unit. A container spends, on average, 6 hours waiting...

10. Which of the following is a key performance indicator (KPI) commonly used in operations management? a) Return on investment (ROI) b) Gross profit margin c) On-time delivery performance d) Market...

Analyze the Design and Methodology in Two Quantitative Studies Recall the two quantitative studies you read for this lesson from the eReserves; use these to answer the following questions: Identify...

Q. 1 Read the small case study about Cadbury Schweppes given below. In the case study it is stated that Cadbury Schweppes uses batch production methods to make its products and that it is important...

The daily demand for parts made at machining workcell JMB is 1600 units. The average processing time is 25 seconds per unit. A container spends, on average, six hours waiting at JMB before it is...

Final Paper Instructions/Guidelines: The final paper must be a minimum of 5 pages and a maximum of 7 pages in APA format. You can find APA guidelines in the Week Six folder under final paper tips....

informs Vol. 34, No. 3, May-June 2004, pp. 191-205 issn 0092-2102 \u0001 eissn 1526-551X \u0001 04 \u0001 3403 \u0001 0191 doi 10.1287/inte.1030.0068 2004 INFORMS Inventory Decisions in Dell's Supply...

check on the file and download the...

a) find saddle-node bifurcation, is it generic? b) draw the bifurcation diagram and phase portraits For the system dx dt dy dt = 2(1 + a)x+2y + x = -y + ax

The temperature of a gas is related to its absolute pressure and specific volume through T = 3.488pv, where T, p, and v are expressed in their standard SI units. Consider a gas at 100 kPa and 1...

E12.25 (LO 4) (Ratio Computations and Effect of Transactions) The following information is related to Leland AG. Leland AG Statement of Financial Position December 31, 2025 Equipment (net) 150,000...

When older adults have difficulty with transportation and communication, or may be reluctant to request needed assistance to which they are entitled, they may be in need of: Group of answer choices...