Question: Problem One The experimental system shown in the figure ( bottom of page ) has two aqueous solutions in contact through a membrane, which is

Problem One
The experimental system shown in the figure (bottom of page) has two aqueous
solutions in contact through a membrane, which is permeable to both Na+and K+.
The solution to the left of the membrane contains 10mMKCl and 1mMNaCl
(Solution 1). The solution to the right of the membrane contains 1mMKCl and
10mMNaCl (Solution 2). In addition, electronics are attached to the experimental
system, so that the observer can apply a potential difference across the membrane.
a. Box 2.5 shows that the flux due to passive diffusion of molecules across a
membrane can be described by:
Jx=K(C1-C2)
where Jx is the flux through the membrane (mols-cm2),K is a permeability
constant , equal to the diffusion coefficient divided by the membrane
thickness, Dx), and C1 and C2 are concentrations in the fluids on the two
sides (molL. If the cross-sectional area of the membrane is 1cm2, the volume
of each solution is 1mL, and K is equal to 10-5cms, show that will it take more
than ) for the concentration of K+to drop by 1%.
b. What is the Nernst potential for K+and Na+across the membrane?
c. What is the net direction of K+and Na+flux under the following conditions: no
applied voltage; -58mV applied to Solution 1(relative to Solution 2); -28mV
applied; 58mV applied; 68mV applied?
d. In this experimental system, if you wanted to confirm that your predictions in
part c were true, is the time period over which you measure the fluxes
important? Describe why or why not.
 Problem One The experimental system shown in the figure (bottom of

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!