PROCESS OBSERVATION SHEET PROCESS/OPERATION: REPAIRING HOUSE UTILITIES PROCESS ANALYST/S: DETERMINING WHAT CAUSES THE PROBLEM OF MAINTANING ITS MATERIALS AND EQUIPMENTS IN HOUSE FACILITIES. 6Ms PROCESS METHOD/ MILLEAU DESCRIPTION | MANPOWER MACHINE MATERIAL MEASURMENTS MONEY (Working Environment) Over the past few decades, the National Fire Alarm and Signaling Code ear-piercing siren (NFPA 72) has Manpower, should emanate mandated the Check smoke Discipline, Smoke Detector Test button and from the smoke P 500.00-1500 installation of alarms training, and Suppliers detector while the smoke alarms in Accountability button is pressed every sleeping area, on every floor of the house, and outside of every sleeping area. A GFCI should be The National Supplier used in any indoor Electrical Code Ground fault circuit Manpower Ground fault or outdoor area currently manual not sent with the help circuit to directed where water may P 1500-2500 requires that interrupters of expert interrupter come into contact GFCIs be used monthly suppliers with electrical in all kitchens, products. bathrooms. garages, and outdoors. For many years Scrape any NFPA 72, loose paint National Fire off with a Alarm and pull Signaling Code, scraper. has required as a minimum that Sand the smoke alarms Check windows surface be installed Manpower Repair Flaking 220-grit for peeling paint smooth inside every with the help Paint sandpaper and P 1500-2500 and wood rot sleep room of expert a putty knife with 120- each year grit (even for sandpaper, existing homes) being in addition to requiring them careful not outside each to scratch sleeping area the glass and on every level of the home. OBSERVATIONS: Keeping up with routine maintenance and repairs is important for a house because they all affect its overall resell value, which is why they should all be kept in good condition. Not only can mechanical symptoms be discovered during the repair process, but environmental and root causes of failure can also be discovered. If the damage can be repaired, new piping and foundation work are unnecessary. The cost of replacing motors and valves can be avoided, saving money