Question: Q - 2 : ( 1 0 Marks ) The cone penetration test was conducted on soil profile at depth of 8 m , the

Q-2: (10 Marks)
The cone penetration test was conducted on soil profile at depth of 8m, the ground water table was at the
ground surface: If the relative density of the soil was Drr=70% and st=20kNm3, Calculate the cone
resistance in )
Q - 2 : ( 1 0 Marks ) The cone penetration test

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

CV 6 3 1 1 4 . ( a ) A Standard Penetration Test ( SPT ) using a donut hammer and a standard split - spoon sampler is carried out in a coarse sand deposit at 8 m below the ground surface. The...

Q:

The cone penetration test was conducted on soil profile at depth of 8 m , the ground water table was at the ground surface. If the relative density of the soil was D r = 7 0 % and s a t = 2 0 k N m 3...

Q:

A soil profile consists of 2 m of sand overlying 10 m of clay. The water table is located at 1 m below the groundsurface. It can be assumed that the degree of saturation of the soil above the ground...

Q:

The sounding from a Cone Penetration Test performed at a bridge site in British Columbia, Canada is shown below ( Niazi et al . , 2 0 1 0 ) . The sounding shows cone tip resistance ( q t ) , sleeve...

Q:

Introduction A proposed shopping complex include a two - storey building located close to one boundary of the site. A section of the foundation plan shown in the figure below consists of series of...

Q:

Background As part of the construction of High Speed 2 ( HS 2 ) , re - landscaping is required to ensure track gradients do not exceed limit values. Soil removal may result in heave , i . e . upwards...

Q:

( b ) A site with a thick original soil deposit had been reclaimed in the past and the consolidation of this layer is complete. A reclamation fill layer of 1 5 m is overlying the original deposit...

Q:

Figure 1 shows a cone penetration test profile in the unknown region through which a 1 6 0 foot long, 1 8 inch diameter, 0 . 3 7 5 inch wall thickness, open ended steel pipe pile was driven. The pile...

Q:

Background Table 1 - Some soil properties \ table [ [ Parameter , Clay,Limestone, ] , [ Unit weight, \ table [ [ Above water ] , [ table ] ] , 1 8 kN / m ^ ( 3 ) , 2 3 kN / m ^ ( 3 ) ] , [ , \ table...

Q:

B . Determine the following: Depth and spacing of bore holes needed for a 4 story office building ( wide concrete ) . Depth and minimum number of bore holes needed for a 3 0 k m highway project. C ....

Q:

Adriana Lopez receives the March bank statement for Success Systems on April 11, 2010. The March 31 bank statement shows an ending cash balance of $77,354. A comparison of the bank statement with the...

Q:

An iron rod 4.00 m long and 0 . 500 cm 2 in cross-section stretches 1.00 mm when a mass of 225 kg is hung from its lower end. Compute Youngs modulus for the iron.

Q:

At the end of 2 0 2 4 , Ivanhoe Company has $ 1 8 2 , 5 0 0 of cumulative temporary differences that will result in reporting the following future taxable amounts. \ table [ [ 2 0 2 5 , $ 5 9 , 1 0 0...

Q:

Williams & Elliott LLC (W&E) is budgeting for next year. Much of the work that W&E does relates to repeat business (quarterly and annual tax filings and annual audits), but the partners also work...