Question: Q 2 Determine the vertical deflection at C using Virtual Work Method if the Young's Modulus of the frame member is 2 0 0 GPa

Q2 Determine the vertical deflection at C using Virtual Work Method if the Young's Modulus of the frame member is 200GPa and its second moment of inertia is 435106mm4 as shown in Figure Q2.
(10 marks)
End of Paper
Q 2 Determine the vertical deflection at C using

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

Deflection Calculation using virtual work method. Determine slope at A and vertical deflection at point D of the beam loaded as shown in the figure below using virtual work method. The cross section...

Q:

Calculate deflection using virtual work method. Determine slope at A and vertical deflection at point D of the beam considering the point load at Z and uniformly distributed load between A & B as...

Q:

roblem 1 (35 pts): The beam ABC is fixed at A, hinged at B, and supported by a roller at C. The reactions at A and Care shown on the figure. Ignore axial and shear deformations. Take E= 200 GPa. l, =...

Q:

Problem 3 : Deflection Calculation ( Virtual work method ) Determine slope at A and vertical deflection at point D of the beam loaded as shown in Figure 3 below using virtual work method. The cross...

Q:

HW 0 4 - 0 4 Determine the horizontal displacement at A . E = 2 9 x 1 0 3 ksi. The moment of inertia of each member is indicated in the figure. Assume D is a pin support and A is a roller. Use method...

Q:

correct Learning Goal: The method of virtual work can be applied to beams and frames. The displacement of a specific point on a beam caused by external loading can be determined using the virtual...

Q:

A truss is shown in the figure. Support E is pinned and Support A is a roller. All theThe beam is depicted in the figure. Assume E l is constant along the beam. Support A is a roller, B is a roller...

Q:

The canopy structure provides shelter by panels attached to the underside of the frame and support beams. Assume the frame \ ( A B C D \ ) is rigid and has a fixed connection at \ ( A \ ) . Assume...

Q:

A steel cantilever beam, of length 2L, has an l-section, see Figure Q3. The cantilever beam is under a uniformly distributed load q = 175 kN/m applied in its vertical plane of symmetry at OA part of...

Q:

Problem 4 . Determine the vertical deflection at point C using the method of virtual work. The moment of inertia of segment A B is I = 5 0 0 ( 1 0 6 ) m m 4 , and the moment of inertia of segment B C...

Q:

Describe a walk-through. How does the auditor use this auditing technique?

Q:

A thin air wedge between two flat glass plates forms bright and dark interference bands when illuminated with normally incident monochromatic light. (a) Show that the thickness of the air wedge...

Q:

1 1 of 1 6 Which of the following affects the present value of an investment? A . The number of time periods ( length of the investment ) B . The type of investment ( annuity versus single lump sum )...

Q:

The charges to Work in Process-Assembly Department for a period, together with information concerning production, are as follows. All placed in process at the beginning of production. Work In...