Question 2: Do Design (USING MULTISIM SOFTWARE) JFET amplifier is used to provide a high input impedance and voltage gain for a whip anterna. When an antenna is connected to the input of a receiver or a coaxial cable, signal deterioration may be unacceptable due to a distant station, noisy conditions or an impedance mismatch. As an electronic engineer, you have been asked to design a broadband amplifier using two JFETs in a cascode arrangement commonly used in RF application based on the engineering principles you have acquired. Please ensure that your design gain voltage must be applicable for FM broadcast band. Your design involves discrete components only. The question must be answered clearly with the help of diagrams Introduction Theoretical Explanation or Literature Review Results Analysis and Discussion . Conclusion