Quesuu Help Refer to Table 561 Factors for Computing Control Chart Limits (3 sigma) for this problem. Sampling 4 pieces of precision cut wire to be used in computer assembly) every hour for the past 24 hours has produced the following results Hour XR Hour XR Hour XR Hour XR 1 3.35% 0.65" 7 295 0.48 13 3.21" 0.85" 193.41" 1.56" 2 3.20 1.188 2.75 1.18 14 2.93 1.36 20 2 79 1.04 3 3.12 1.439 2.92 0.76 15 3.221.01 212.65 1.03 4 3.29 1.31 10 2.05 133 16 2.84 0.45 22 3.18 0.41 5 317 1.22 11 2.73 1.17 12 286 1.38 23 304 1.53 6 2.96 032 12 3.07 0.40 18 2.74 1.34 2 4 2.54 0.97 Based on the sampling done, the controllimit for 3 slama x chart are fround an intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL) - inches (round your response to three decimal places) Mean Factor, Lower Range, Sample Size, n A2 1.880 1.023 0.729 0.577 0.483 0.419 0.373 0.337 0.308 0.266 Upper Range, D 3.268 2.574 2.282 2.115 2.004 1.924 1.864 1.816 1.777 1.716 0.076 0.136 0.184 0.223 0.284