(Single cycle Implementaion datapath)

.Modify the data path and control for the single-cycle implementation shown on the following page to add the instruction jr Gump register). You should also indicate each of the appropriate settings for the control lines to support the jr instruction in the table above. You can assume that the opcode field uniquely identifies the jr instruction. (5 points) Instruction[25-0] Jump address [31-0 Shift) ft.. |PC + 4[31-28] Add ALU RegDst Jump Shift left 2 ran MemRead MemtoReg Instructional-2 Control RegWrite PRead PC-address register 1 Read Zero Instructiorn Oregister 2 ALU Write Read resultAddress Reao Instruction memory terat 2 dataM Write data Registers Write Datar data memory [15-01-+--extend 16 /sign Sign- 32 - . ALU -(control control Instruction |5-0) 0