Styles on was implemented, all three routers should have a connected route to et, and a static route to each of the other two LAN subnets. Router Triangle Lab 4: OSPF Interface Config Requirements Configure OSPF for the lab network shown in the figure. However, do not use the traditional configuration with network commands in OSPF configuration mode. Instead, use OSPF interface configuration. The specific rules for this lab are: Configure so each router uses a router-id of X.XX.X where x equals the router number. Do not rely on interface IP addresses for the setting of the router IDs. Use OSPF area 0 for all interfaces Enable OSPF directly on each interface, rather than using the indirect method and the OSPF network command Assume all interfaces shown in the lab are up and working tion or Screenshot of your results Deliverables: 172.21.1.0/25 172.22.2.0/20 G03 G0/3 GO/1 172.30.1.0/30 30/2 R1 G0/2 R2 G0/1 172.30.1.8/30 172.30.1.4/30 GO/1 GO/2 R3 I GO/3 172.23.3.0/27 Show running configuration or Screenshot of your results