Tweaking the Initial Assembly$-$LineDesign From past experience, the engineering manager has found that the initial assembly$-$line design supplied by the engineers often needs to be tweaked. Consider the following questionsthat the manager is considering: $1.$ What is the daily capacity of the assembly line designed by the engineers? Assume that the assembly line has a computer at every position when it is startedat the beginning of the day. $2.$ When the assembly line designed by the engineers is running at maximum capacity, what is the efficiency of the line relative to its use of labor? Assume that thesupporter is not included in efficiency calculations. $3.$ How should the line be redesigned to operate at the ini$-$ tial $250$ units per day target, assuming that no overtimewill be used? What is the efficiency of your new design? $4.$ What about running the line at $300$ units per day? If overtime were used with the engineers' initial design, how much time would the line need to be run eachday? $5.$ Design a new assembly line that can produce $300$ unitsper day without using overtime. $6.$ What other issues might the manager consider whenbringing the new assembly line up to speed?