Question: Two 1 2 mm thick by 5 0 mm wide aluminum tie rods are welded with fi xed welds in a lap joint by means

Two 12 mm thick by 50 mm wide aluminum tie rods are welded with fi xed welds in a lap joint by means of an aluminum electrode.
with fi lete welds in a lap joint, using an aluminum electrode.
Calculate the necessary size of the fi le weld for a dynamic load varying from 0 to 5kN, with a factor
5kN, with a safety factor of 2.0, for infi nite life of the two full-length welds.
of the two full length welds.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

Assignment #2: Preparing for upcoming terminations Instructions Thread & Fibre, a household linens manufacturer, operates in Ontario and Quebec. The organization currently has 150 employees and a...

Q:

For the following three questions, state if you would solve the problem as being in equilibrium, steady state, or neither. A 20 m thick membrane of Pd is exposed to a hydrogen atmosphere with pH2 =...

Q:

Q-1 A motor car shaft consists of a steel tube 30 mm internal diameter and 4 mm thick. The engine develops 10 kW at 2000 r.p.m. Find the maximum shear stress in the tube when the power is transmitted...

Q:

12. A refrigerator wall consists of low-carbon steel (1C) 1 mm thick on the outside, 2 mm thick poly- styrene inside, with 2 cm thick expanded cork between as an insulation, as shown in Figure P2.12....

Q:

Repeat the calculations of Examples 4.6, 4.7, 4.8, and 4.9 for a column diameter corresponding to \(50 \%\) of flooding. Data From Example 4.6:- Design a sieve-tray column for the ethanol absorber of...

Q:

A figure below shows a cross section view of a cold storage room. The room is maintained at -30C. The surrounding air outside is at 35C and 60% RH. The dew point temperature is 20C. The wall is...

Q:

3. Consider a chip package similar to the case study as below. The die is dissipating 2 W. The thermal interface material is a 0.127 mm thick layer of epoxy, and the mold compound is 2 mm thick....

Q:

Your humble professor is an old man, with one foot in the grave. As such, my back hurts merely for existing. Hot patches can work to relieve back pain. Upon exposure to oxygen, the iron in the...

Q:

Q1. (a) Explain the following term with ONE example in your daily life. (1) Equimolar counterdiffusion (7 marks) A diffuse through non-diffusing B (4 marks) (b) Ethanol vapor is absorbed from binary...

Q:

(a) Bicycle Rack When a full design specification was produced and the weighted objective procedure carried out, it was found that a tow bar mounted rack was the best solution. This would bolt to the...

Q:

Two volumes of Newmans The World of Mathematics stand side by side, in order, on a shelf. A bookworm starts at page i of Volume I and bores its way in a straight line to the last page of Volume II....

Q:

Hamid, age 40 wants to retire at age 65. He will collect CPP of $14,000 and OAS of $7,500 at that time. His only other asset is RRSPS worth $150,000. He says his retirement expenses (needs) are...

Q:

You have $100,000 that you would like to invest. You have three investment choices: Savings Account A which earns 5% APR compounded annually, Savings Account B which earns 4.92% APR compounded...

Q:

what is the specific sub - paragraph in the ASC where FASB provides the examples of noncash transactions that must be disclosed? Sample format: ASC XXX - XX - XX - X ,

Q:

Oriole Corporation uses the percentage-of-completion method. At the end of the first year of a $9016000 contract, the following information is available: Costs to date: $2014250 Estimated costs to...