Use Packet Tracer to do lab for RIP

Configure for RIPv2 and show all the codes for each following steps.

1. Configure basic settings for each router.

2. Configure PCs with IP addresses and gateways.

3. Configure RIPv2 routing in each router.

4. Examine RIPv2 is running in each router using the commands ``show ip route and ``show ip protocols

5. Verify the connectivity of PC2 and PC3 using ping.

6. Take screenshot for ``show ip route and ``show ip protocols of Router2 and Router3; ping from PC2 to PC3 and from PC3 to PC2.