Question: Use Packet Tracer to do lab for RIP Show all the codes for each following steps. 1. Configure basic settings for each router. 2. Configure

Use Packet Tracer to do lab for RIP
Show all the codes for each following steps.
1. Configure basic settings for each router.
2. Configure PCs with IP addresses and gateways.
3. Configure RIPv1 routing in each router.
4. Examine RIPv1 is running in each router using the commands ``show ip route and ``show ip protocols
5. Verify the connectivity of PC0 and PC1 using ping.
6. Take screenshot for ``show ip route and ``show ip protocols of Router0 and Router1; ping from PC0 to PC1 and from PC1 to PC0.
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
