Question: Which command is used to add entries to a routing table? A . Create route B . Show route C . Add route D .

Which command is used to add entries to a routing table?
A. Create route
B. Show route
C. Add route
D. IP route

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!

Q:

What are the three major types of product costs in a manufacturing company?

Q:

Week 5-- OSPFv2 Configurations 1) Subnet the network, given the IP = 192.168.10.0 /24 LAN 1 = 30 Hosts /27 =255.255.255.224 27 26 = 1, 21 = 2 subnets Block size = 256 224 = 32 192.168.10.64 /27 (.65...

Q:

Refer to the figure and the output of the show ip protocols command. Which two EIGRP metrics are being used to affect the calculation that selects the best path to add to the EIGRP routing table? (...

Q:

b) c) d) 42 it is common for network professionals to use commands for network administration and configuration. Write the commands that you would use to achieve the following: Display the Internet...

Q:

The solution is required On Cisco Packet Trace r Thank you :) Today's Lab: In this lab, we will learn how to configure Static Routing on the Routers 192.168.10.1 192.168.10.2 192.168.1.1 1941...

Q:

No wrong answers please follow the instructions and answer questions appropriately!!!!! (Wlk4) Activity- Troubleshooting Static and Default RoutesTemplate. 1. Copy and paste the running configuration...

Q:

1. (1pt) Use Cisco Packet Tracer to create the network shown above. Submit a screenshot of the network your created. 2. (1pt) Configure the hostnames, IP addresses, subnet masks, and default gateways...

Q:

Configuring Network Address Translation (NAT) Documentation Task 1 . From the attached hosts, ping the Fast Ethernet on 10.10.10.1 interface of the default gateway router. Was the ping from the first...

Q:

Using GNS3 interconnect and configure the routers to achieve end to end connectivity. Use the IP addresses assigned to you.Recommendation I would advise you to use a /24 (255.255.255.0 netmask) for...

Q:

Which command will provide information specific to OSPFv2 routes in the routing table? show ipv6 route ospf show ipv6 route show ip route ospf show ip route ospf show ip route ospfv3

Q:

QUESTION 9 What type of static route is created when the next-hop IP address and exit interface are specified? fully specified static route directly connected static route floating static route...

Q:

For a cartilage tissue with the thickness h = 1.79 mm, perfusion area A=6.25 mm2 , and permeability k= 4.61015 m4 /N-sec, calculate the volume flux across the tissue if the fluid Pressures P1 and P2...

Q:

Two different manufacturers, M1 and M2, produce light bulbs. A bulb produced at manufacturer M1 is broken with a probability of 0.06, and each bulb produced at manufacturer M2 is broken with a...

Q:

Using the loopholes of law to reduce tax is known as Question 1 0 Answer a . Tax evasion b . Tax planning c . Tax avoidance d . Tax management

Q:

Assume that a sample is used to estimate a population proportion p. Find the margin of error E that corresponds to the given statistics and confidence level. Round the margin of error to four decimal...