Question: Why do we use a Copper Straight - Through cable to connect Host - A to the WRT 3 0 0 N router

Why do we use a Copper Straight-Through cable to connect Host-A to the WRT300N router

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!

Q:

OBJECTIVE To overview of the Packet Tracer Program. EQUIPMENTS/SOFTWARE USED No Name of the Component / Equipment /Software 1 Packet Tracer Software...

Q:

CSIS2270-Introduction to Cisco Packet Tracer Introduction: Packet Tracer is a network design, simulation and modelling tool that allows you to develop your skill set in networking, cybersecurity, and...

Q:

Submit a Microsoft Word document with screenshots of your completed topology and ping tests. Your topology should identify the modifications described below: Modify the Marketing subnetwork. Add a...

Q:

Cis 145- Networking Week 6 hands on project Open packet tracert- add the following to your workspace a. 4 PCs b. two PT-switched c. three PT-routers use copper straight through cables to connect all...

Q:

answer all questions accordingly pls Cold Boot Switch/Router 1) ROM-POST (Power on Self-Test)-Several diagnostic programs that tests the hardware of the router 2) ROM-Bootstrap-check the...

Q:

3 / 9 100% + Objective II: Study serial defaults Enter a command on Router that reports the status and parameters of the interface Serial0/0/0. What's the interface's Physical and Data Link layers'...

Q:

Cisco Networking Academy Mind Wide Open Lab 1.5.2: Basic Router Configuration Topology Diagram 192.168.1.0/24 192.168.2.0/24 192.168.3.0/24 PC1 Fa0/0 S0/0/0 DCE S0/0/0 Fa0/0 PC2 ----- R1 R2...

Q:

Lab 1: Introduction to Packet Tracer Lab 1: Introduction to Packet Tracer Total Marks= 10 Objectives of this Lab: The goal of this lab is to become familiar with building topologies in Packet Tracer...

Q:

1. Open Packet Tracermake sure youre starting from a new file, not an existing network. 2. Add a pT-router, a pT-switch, and two pCs. Configure these devices with the following information: a....

Q:

Please Provide screen shots and answer the questions please thank you 1. Open Packet Tracermake sure youre starting from a new file, not an existing network. 2. Add a pT-router, a pT-switch, and two...

Q:

Calculate i0 (t) for t > 0 in the network of Fig. 16.51. 2e u(t) V 41(1) A 1.0

Q:

A sphere of radius R carries charge density proportional to the square of the distance from the center: p= Ar2, where A is a positive constant. At a distance of R/2 from the center, the magnitude of...

Q:

Using the following information, prepare a trial balance. Assume all asset, dividend, and expense accounts have debit balances and all liability, stockholders' equity, and revenue accounts have...

Q:

Waterworks Parks design includes all of the following except