You have an assembly process that yields a final dimension that is to be controlled. The target value for this dimension is $75$ mm$.$ You also note that the design specifications are not symmetric, but instead given by X$*=75+2/-3.$ Upper specification limit equals USL$=77$ and lower specification limit equals LSL$=72.$ Process measurements show that for every $20,000$ parts produced you are seeing $17$ parts out of specification, with a nearly even split between parts being above the upper specification limit and below the lower specification limit$.$ They also give a standard deviation of $0\mathrm{.}75,$ what would be the corresponding value for process capability CP and CPK$.$