You know that it is very important to verify that your measurement system can provide accurate information

about your process during the Measure stage. You are concerned because your internal inspection records

don't show the same defect rate as TTI is reporting, so you decide to perform a Gage R&R study on your final,

and most critical, test point to make sure that your measurement system is giving you the right information

before you go any further into the project. Here are your MSA results:

Instructions: Review these results and answer the following two questions

Is your final test measurement system acceptable? Why or why not? Explain your answer as if you are

explaining it to the process owner.

Given these results, what is the biggest problem with this measurement system, how do you know this, and

what would you do to correct it$?$