We would like to produce a 2-in.-thick steel wear plate for a rock-crushing unit. To avoid frequent
Question:
We would like to produce a 2-in.-thick steel wear plate for a rock-crushing unit. To avoid frequent replacement of the wear plate, the hardness should exceed HRC 38 within 0.25 in. of the steel surface. The center of the plate should have a hardness of no more than HRC 32 to ensure some toughness. We have only a water quench available to us. Design the plate, assuming that we only have the steels given in Figure 13-21 available to us.
Fantastic news! We've Found the answer you've been seeking!
Step by Step Answer:
Related Book For
The Science And Engineering Of Materials
ISBN: 9781305076761
7th Edition
Authors: Donald R. Askeland, Wendelin J. Wright
Question Posted: