A stainless steel rod has a square cross section measuring 1 by 1 cm The rod length is 8 cm, and k 18 W m C The base temperature of the rod is 300C The rod is exposed to a convection environment at 50C with h 45 W m2 C Calculate the heat lost by the rod and the fin efficiency

Question: A stainless steel rod has a square cross section measuring 1 by 1 cm. The rod length is 8 cm, and k = 18 W/m

A stainless steel rod has a square cross section measuring 1 by 1 cm. The rod length is 8 cm, and k = 18 W/m · ºC. The base temperature of the rod is 300ºC. The rod is exposed to a convection environment at 50ºC with h = 45 W/m2 ∙ ºC. Calculate the heat lost by the rod and the fin efficiency.

Step by Step Solution

★★★★★

3.33 Rating (165 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

mL c 2688 4 03694... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

892-P-T-H-T (634).docx

120 KBs Word File

Students Have Also Explored These Related Thermodynamics Questions!

A duct with square cross section measuring 20 cm by 20 cm has water vapor at 1 atmosphere and 600 K flowing through it. One wall of the duct is held at 420 K and has an emissivity of 0.8. The other...

A steel bar has a square cross section of width b = 2.0 in. (see figure). The bar has pinned supports at the ends and is 3.0 ft long. The axial forces acting at the end of the bar have a resultant P...

A long stainless-steel rod [k = 16 W/m C] has a square cross section 12.5 by 12.5 mm and has one end maintained at 250C. The heat-transfer coefficient is 40 W/m2 C, and the environment temperature...

270 Chapter 4 Applications of Derivatives c. What is the largest area the rectangle can have, and what are its dimensions? 12. Find the volume of the largest right circular cone that can be in- X...

(1) An asbestos pad is rectangle in cross section, measuring 3 cm x 10 cm on a side at its small end, increasing linearly to 6 x 20 cm on a side at the large end. The pad is 20 cm high. If the small...

A stainless steel rod with a length of 6 0 cm , diameter of 1 cm and thermal conductivity of 1 8 W / m . C is attached to a large tank at constant temperature of 2 0 0 C . The rod is dissipating heat...

Hi, I'm studying for my test and would like some answers/feedback to check against. Can I get help with the uploaded document (Math 130 2017) particularly 4, 8, 9 &10? 1. [12 Marks] 2. [12 Marks}...

1. A piece of aluminum with a mass of 250 g is immersed in a trough of water filled to the brim. The mass of the overflown water is measured and found to be 93.0 g. What is the density of the piece...

Fill in the missing information in Table P-4, indicating whether the theoretical autocorrelations and partial autocorrelations die out or cut off for these models. TABLE P-4 Model Autocorrelations...

What are the primary responsibilities of the Federal Reserve System?

3.3 The figure for this exercise is a scatterplot of y 5 average math SAT score in 1998 versus x 5 percent of graduating seniors who took the test that year for the 50 states and the District of...

Which of the following best describes the administer procurements process? A. Obtaining seller responses, selecting a seller, and awarding a contract B. Managing procurement relationships,...

The temperature of air flowing through a 25-cm-diameter duct whose inner walls are at 320C is to be measured with a thermocouple soldered in a cylindrical steel wall of 1.2 cm OD, whose exterior is...

Develop an expression for the ratio of the rate of heat transfer to water at 40C from a thin flat strip of width D/2 and length L at zero angle of attack and a tube of the same length and diameter D...

Repeat Problem 7.17 for air flowing over the same two surfaces in the Reynolds number range between 40,000 and 200,000. Neglect radiation. From Problem 7.17: Develop an expression for the ratio of...

The common stock of the C . A . L . L . Corporation has been trading in a narrow range around $ 1 0 5 per share for months, and you believe it is going to stay in that range for the next 6 months....

(Part A, B, C for requirement 2 are already correct) Consider the following information on Stocks I and II: Calculate the beta and standard deviation of Stock I. (Do not round intermediate...

help please 14. [40.15 Points] DETAILS BBUNDERSTAT12 6.2.0233. MY NOTES ASK YOUR TEACHER PRACTICE ANOTHER Sketch the area under the standard normal curve over the indicated interval and find the...