$(2)$ Based on the tolerances specified in $2\mathrm{.}1,$ is the part shown below an acceptable part? Why or why not? Answer the following questions using the drawing below:

What is the MMC$?$

What is the LMC$?$

What is the geometric tolerance?

What material condition modifier is specified?

What datum feature$($s$)$ control$($s$)$ perpendicularity?

What datum feature$($s$)$ control$($s$)$ location?

Using the drawing provided in question $4,$ complete the table below for the hole.

Table $1.$ Total position tolerance for the hole ISE $2360$ Design for Manufacturing

Lecture Assignment $4$

Due date: Refer to the syllabus.

$(1)$ Add geometric tolerances to the drawing below that specify a flatness control of $\mathrm{.}005$ for the top

surface of the part.

$(2)$ Is the part in the figure below an acceptable part. Why or why not?

$(1)$ Finish the geometric tolerances of the pin shown below according to the requirements.

$($a$)$ The pin has a nominal diameter of $\mathrm{.}990$ inch with a tolerance of $+\mathrm{.}000,-\mathrm{.}010$;

$($b$)$ The perpendicularity of the pin w$.$r$.$t the datum A is $\mathrm{.}010$ at MMC$.$

What is the difference between the two tolerancing methods for the position of the hole?