2, Design a circuit which will control LED segment"c" of a 7-Segment display. o See the diagram below to understand what a "c" segment is o If the segment is lit, then the output should be 1. If the segment is not lit, then the output should be 0 o For example, for the numbers 0, 3, and 4, segment "c" should be lit for numbers 1, and 2, segment"c" should not be lit; etc. o Design the circuit so that if someone applies a value from 10 to 15 then the LED segment does not light. The following guidelines apply to the 2nd part of the lab assignment: o You may only use NAND and NOT gates (it is common to have your design limited to certain gates) o Show all the steps of the combinational design procedure including test results o Present the simplified SOP form after using the Karnaugh map reduction method o Present the expression that can be implemented by using NAND and NOTgates o Print out the circuit when inputs are 1, 3, 9 and 11 o A 7-segment display can display the digits 0 - 9 by having the appropriate LEDs turned on