A customer has asked for process capability on a particular process. The control charts, created with a sample size of n = 5, in place show that the centerline (XDB) is 0.50349 with a range of 0.00014. The specifications for this process are 0.50350 + - 0.00020 mm. The Cp value is: Process capability: Cp=USL-LSL (allowable spread) 60 (spread of process) Estimating Population Standard Deviation: n -- - -----OR-.-. Icontent/enforced1/2749074-201950MGMT434001/Control Chart Table 7 pdf 1.1 6.66 -0.7 A customer has asked for process capability on a particular process. The control charts, created with a sample size of n = 5, in place show that the centerline (XDB) is 0.50349 with a range of 0.00014. The specifications for this process are 0.50350 +/- 0.00020 mm. The Cpk value is (round): Process Centering: Cpk=Z(min) where Z (min) is the smaller of: Z(USL)=USL: ---OR? Z(LSL)= g-LSL I 03.17 O 1.1 3.5 0 2.4 A customer has asked for process capability on a particular process. The control charts, created with a sample size of n = 5, in place show that the centerline (XDB) is 0.50349 with a range of 0.00014. The specifications for this process are 0.50350 +/- 0.00020 mm. What should the customer be told about process capability? (Use Cp & Cpk from questions 8 & 9) The process is not centered and but is barely capable. O Che process is not centered and not capable. The process is centered and capable. The process is centered, but not capable