Question: A D latch is _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

A D latch is_____________________.
a.
a level-sensitive sequential logic device
b.
a negative-edge triggered device
c.
a level-sensitive combinational logic device
d.
a positive-edge triggered device

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

d latch positive LEVEL triggered. what is the difference between positive edge? it seems very similar to level and I was looking online but I can't tell what the difference is and know it varies...

Q:

b) D Latch, Positive LEVEL triggered! D H OUT Clock Clock OUT

Q:

SR LATCH & D LATCH 4.1 OBJECTIVE In this experiment we will construct a few simple latch circuits, and realize the truth tables. 4.2 EQUIPMENT LIST Digital Training set Y-0039, Logic Gates: 7404...

Q:

Given the following circuit, complete the timing diagram shown below assuming that the propagation delays for each component is as follows: D - Latch Propagation Delay Time a 5 ns Delay time for the...

Q:

please solve this question 8. If both inputs of an S-R Latch are ZERO, what will happen when the clock goes ONE? A. An invalid state will exist No change will occur in the output C. D The output will...

Q:

Part 1 : Simulate an SR - Latch Implement the NOR - gate SR latch ( not level sensitive ) that we discussed in class: A ) Create a simulation / schematic in Digital Software. Verify that the circuit...

Q:

PRELAB ONLY Lab #6 Flip-Flops Purpose: The goal of this lab is to design two latches and a flip-flop using combination logic gates. Procedure: 1 Construct an SR latch with an enable using a single...

Q:

3.0 D Latches In a new project lab9step2 build a Gated D Latch using NAND gates and a NOT gate. Refer to Section 5.3 for a detailed explanation of D Latches. Figure 5.7a shows how to build a D Latch...

Q:

5.1.a Fill in truth table for the following latch made from cross coupled NAND gates. A BQ(t) y(t) Q(t+delta) y(t+delta) 5.1.b what would be a good label for the inputs A and B in terms of their...

Q:

using logism 7. Create a R-S Latch from NAND gates in Logisim chip name: R-S Latch inputs: r, s outputs: result function: See R-S Latch from text and slides 8. Create a Gated D Latch from NAND gates...

Q:

What is relational database and what are its types? Explain with Examples.

Q:

Calculate the amount of heat released from combustion of 1g of wood. The heat capacity of the bomb calorimeter is 9.96 kJ/"C. kJ

Q:

Please fix all the wrongs in the question. Recalculate to make the right in the same format you see. Question 1 Partially correct Mark 12.92 out of 20.00 Flag question Forecast Income Statement and...

Q:

Pandora Corporation operates several factories in the Midwestthat manufacture consumer electronics. The December 31, 2024,year-end trial balance contained the following income statementitems:Sales 2...