A tool on a disk moved by a motor is controlled using one push-button as follows: Initially, the tool is at point A. When the push-button (S) is pressed and released, the machine is turned on. When the machine is on, the following tasks are performed in sequence: SO The motor moves the tool 3600 in the clockwise direction and stops the tool at point A for 2 seconds. This cycle is repeated 3 times. The motor moves the tool 3600 in the counter-clockwise direction and stops the tool at point A for 2 seconds. This cycle is repeated 3 times. o The machine turns off. O O A sensor (LA) is used to detect the tool at point A. Ladder PLC program. Write the Page 1 of 1 (LA O A