Question: Considering the closed - loop feedback control system below, indicate in which range the gain value of the system should be . According to this

Considering the closed-loop feedback control system below, indicate in which range the gain value of the system should be.According to this output, write down the range in which the K values of the feedback control system should be.The characteristic polynomial should be written as 1+G(s)H(s)=0.Can you solve this problem from matlab
Considering the closed - loop feedback control

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

After Reading the Case. Clearly answer the following questions in a single post. 1) In your opinion , How did ChassisCo contribute to the cause of crisis at Athens in 2004? How did Toyota contribute...

Q:

Figure below shows a heating process where the process fluid is supposed to be heated to the value of the set point SP by the feedback control system. The following are estimates of the transfer...

Q:

1. A system with unity negative feedback has the following characteristic equation 1+k s(s+4) s2+28+2 (1) Sketch the root locus, (2) Find the gain when the roots are equal, and (3) Find the value of...

Q:

2. What should Martin have done earlier in the project timeline to prevent delays? ( detailed answer) Chris, what do you mean, we can't deploy the system on time? It's a month before the end of the...

Q:

Question \ # 2 ( 7 . 5 Marks ) The root locus of a unity feedback system is shown in Figure. a . What are the open loop poles and zeros? b . What is the range of gain \ ( k \ ) that yields an...

Q:

Chris, what do you mean, we can't deploy the system on time? It's a month before the end of the project and now you're telling me that we may not deploy on time! Do you know what this means? Don't...

Q:

Chris, what do you mean, we can't deploy the system on time? It's a month before the end of the project and now you're telling me that we may not deploy on time! Do you know what this means? Don't...

Q:

Instructions: - Submit a report containing a detailed description of all the tasks. - Provide MATLAB / SIMULINK files used to simulate the tasks. - Provide the MATLAB plots wherever necessary. All...

Q:

Fig . 1 : Closed loop temperature control of a Heat Exchanger Tasks: Section - A: Dynamic performance and control system design of the heat exchanger The transfer functions for the heat exchanger,...

Q:

The mean time between failures for a certain production machine is 250 hours, and the mean time to repair is 6 hours. Determine the availability of the machine.

Q:

How do the police powers of the Constitution affect transportation?

Q:

Ending equity Katys Cooking School Balance Sheet December 3 1 2 0 1 X Assets \ table [ [ , ] , [ , ] , [ , ] , [ , ] , [ , ] , [ , ] , [ , ] , [ , ] ] Net equipment Total Assets Liabilities \ table [...

Q:

Calculating Profit Sharing Pay Awards In your new role as compensation analyst, you have been asked to estimate the dollar amount of the profit-sharing pool based on three approaches as well as the...