Question: During orthogonal machining with a cutting tool having a 1 0 0 rake angle, the chip thickness is measured to be 0 . 4 mm

During orthogonal machining with a cutting tool having a 100 rake angle, the chip thickness is measured to be 0.4 mm, the feed is given as 0.23 mm/min and the principal cutting angle is given as 70. Determine the shear plane angle.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

During orthogonal machining with a cutting tool with a 1 0 degree rake angle, the chip thickness is measured to be 0 . 4 mm , and the uncut thickess is 0 . 1 5 mm . Calculate ( i ) the shear plane...

Q:

2 0 . 5 ( A ) ( USCS units ) A turning operation is performed using a rake angle of 1 5 . Cutting speed = 2 0 0 f t m i n , feed = 0 . 0 1 2 i n r e v , and depth of cut = 0 . 1 0 0 i n . The chip...

Q:

. Figure 5 shows the slip-line field for machining using a cutting tool with restricted contact length 1. Assume that the friction coefficient at the tool rake face is . The shear yield strength of...

Q:

During turning a steel round of 160 mm diameter at 560 rpm employing a feed of 0.32 mm/rev and depth of cut as 4 mm by a ceramic insert having nomenclature 0, -10, 6, 6, 15, 75, 0 (mm), the following...

Q:

1. Shear plane angle and shear strain: In an orthogonal cutting operation, the tool has a rake angle = 15. The chip thickness before the cut = 0.31 mm and the cut yields a deformed chip thickness =...

Q:

In a cutting operations which is performed with a cutting tool with a normal rake angle of 20 and a clearance angle of 7 a machining power of 1850 J/s is used to machine a part at a cutting velocity...

Q:

In a cutting operation, which is performed with a cutting tool with a normal rake angle of 2 0 and a clearance angle of 7 , a machining power of 1 8 5 0 J / s is used to machine a part at a cutting...

Q:

A 1 3 . 5 mm diameter steel shaft is made from a 1 5 mm round bar in one pass. The chip thickness was measured to be 1 . 8 mm . The cutting force was measured to be 1 kN . The spindle is rotating at...

Q:

A tube with 2 mm in thickness and 7 6 mm in outside diameter is orthogonal cut using a 5 rake angle cutter on a lathe. The cutting forces are measured by a tool dynamometer. The cutting and thrust...

Q:

find the evaluate of the hyperbola x^2/a^2 - y^2/b^2 =1 and hence ded_ the evolute of a rectangular hyperbola. be

Q:

An electron moving along the positive x axis perpendicular to a magnetic field experiences a magnetic deflection in the negative y direction. What is the direction of the magnetic field?

Q:

Lansing Company's currentyear income statement and selected balance sheet data at December 3 1 of the current and prior years follow. \ table [ [ UNSTWE CONPAWY ] , [ Incose Statement ] , [ For...

Q:

(0)III. Tan Company sells laptop computers. Inventory is maintainedusing the perpetual inventory system. All purchases of inventoryare on account; accounts payable are paid in the month afterpurch 1...