Question: For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on

For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
Decreases the pressure drop
Decreases the outlet temperature of cooling medium
Increases the overall heat transfer coefficient
None of these

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

Q:

For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it Decreases the pressure drop Decreases the outlet...

Q:

For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it Decreases the pressure drop Decreases the outlet...

Q:

Shell and Tube Heat Exchanger Example Two simple water - water heat exchangers ( both fluids are water ) : concurrent flow one and countercurrent flow one. U for both heat exchangers = 4 . 6 5 1 B t...

Q:

HOMEWORK PROBLEMS 1. Classify the following as either batch or continuous pro- cesses, and indicate whether each is a steady-state or an unsteady- state process: a. A "surge tank" is used when a...

Q:

Find the mass velocity (Gb) in kg/m2-s. A shell and tube heat exchanger with (1-1) configuration is used to cool n-propanol from 90C to 40C at a mass flow rate of 35 kg/s. The heat exchanger consists...

Q:

Water with a mass flow rate of 13,500 kg/h is heated from 35 to 55C in a tube and shell heat exchanger. A single pass of water at 7,000 kg/h and 95C is used on the shell side as the heating fluid....

Q:

1-Find the heat transfer coefficient on the shell side in W/m2-K using the Donohue equation. 2-Find the mass velcity (Gb) in kg/m2-s. 3-Find the mass velocity (Ge) in kg/m2-s. A shell and tube heat...

Q:

As shown in Figure 1, one portion of the hot flue gases is supplied to the steam generator. The steam generator is a shell and tube type of heat exchanger. In this steam generator treated bore water...

Q:

12. Find the heat transfer coefficient on the shell side in W/m2-K using the Donohue equation. A shell and tube heat exchanger with (1-1) configuration is used to cool n-propanol from 90C to 40C at a...

Q:

You are required to solve some design problems for a one - shell two - passes shell - and - tube heat exchanger to cool down hot reaction products dissolved in water ( you can assume properties for...

Q:

A satellite has a space tether, a mass on the end of a long conducting cable, which as it moves through the earths magnetic field is capable of generating a 5.0 kV potential, and a current flow of...

Q:

Three infinite lines of charge, pl = 3 (nC/m), Pl = 3 (nC/m), and Pl3 = 3 (nC/m), are all parallel to the z-axis. If they pass through the respective points (0, -b), (0,0), and (0,6) in the x-y...

Q:

the SML valid for. and the CML is valid for both well - diversified portfolio and individual assets

Q:

please answer all the questionss.,.within 30 minutes. make sure the explanation and reasons are explained in very detailed manner else leave it for other tutor otherwise i will give negative ratings...

Q:

4. If an economy has fully flexible prices and demand unexpectedly increases, you would expect that the economys real GDP would tend to: LO26.4 a. Increase. b. Decrease. c. Remain the same.

Q:

8. Are all prices in the economy equally inflexible? Which ones show large amounts of short-run flexibility? Which ones show a great deal of inflexibility even over months and years? LO26.5

Q:

5. If the demand for a firms output unexpectedly decreases, you would expect that its inventory would: LO26.4 a. Increase. b. Decrease. c. Remain the same. d. Increase or remain the same, depending...