Full adder of 4 bits:

1. Build a 4-bit Full Adder using the two 2-bit Full Adders. Remember that the first carry in goes ashore.

2. Connect each 330 ohm resistor to each sum of the Adders and the last carry out, then the resistors go to ground.

3. Use a voltage of 3V to simulate a logic 1.

4. Fill in Table 10-1 on your answer sheet with the results you found.

Index mark Si A2 8,3 +5 V-4 Co-5 NC-6 NC-17 14A 13-B 12-S, 10: 10C 9-NC BNC NC-not connected Figura 47 Index mark Si A2 8,3 +5 V-4 Co-5 NC-6 NC-17 14A 13-B 12-S, 10: 10C 9-NC BNC NC-not connected Figura 47