I need help completing this operations management question, please. The table referenced, is also included above.

Refer to Table 56.1 - Factors for Computing Control Chart Limits (3 sigma) for this problem. Sampling 4 pieces of precision-cut wire (to be used in computer assembly) every hour for the past 24 hours has produced the following results: Hour Hour R 1 2 3.15" 3.00 3.32 3.39 3.17 2.86 R 0.76" 1.23 1.38 1.26 1.12 0.42 Hour 7 8 9 x R 3.15" 0.53" 2.55 1.08 3.12 0.76 2.95 1.33 2.93 1.22 2.97 0.40 Hour 13 14 15 16 17 18 R 3.01" 0.85" 2.83 1.36 3.02 1.01 2.74 0.45 2.96 1.43 2.64 1.34 19 20 21 22 23 24 3.41 2.89 2.55 3.18 2.94 2.74 1.56" 1.09 1.03 0.51 1.63 0.92 4 5 6 10 11 12 Based on the sampling done, the control limits for 3-sigmax chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL;) - inches (round your response to three decimal places). Lower Control Limit (LCL;) - inches (round your response to three decimal places). Based on the x-chart, the wire cutting process has been The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCLR) = inches (round your response to three decimal places). 1 Definition - X Lower Control Limit (LCLR) - inches (round your response to three decimal places). Based on the R-chart, the wire cutting process has been Lower Range, D3 Sample Size, n 2 3 4 5 6 7 8 9 10 12 Mean Factor, A2 1.880 1.023 0.729 0.577 0.483 0.419 0.373 0.337 0.308 0.266 Upper Range, D4 3.268 2.574 2.282 2.115 2.004 1.924 1.864 1.816 1.777 1.716 0 0 0 0 0 0.076 0.136 0.184 0.223 0.284 Enter your answer in each of the answer boxes. Print Done