Instructions Attached a network design that you need to implement in Cisco Packet Tracer. You will need to add 1840 routers and add ethernet parts to some of them. Also, you will need to enable connection from any PO in the design to any other PC using the ping command. To enable connectivity you will need to use static route. To enable static router on a router to reach network 192.168.5.0 network with mask 255.255.255.0 from RouterO, follow the commands below: RouterO> enable RouterO# conf t RouterO(config)# ip route 192.168.5.0 255.255.255.0 192.168.4.2