Question: MIPS Help asap! Consider a processor implementation, P1 of some RISC (MIPS or risc-v) instruction set architecture (ISA). There are three classes of instructions (ALU,

MIPS Help asap!

MIPS Help asap! Consider a processor implementation, P1 of some RISC (MIPS

Consider a processor implementation, P1 of some RISC (MIPS or risc-v) instruction set architecture (ISA). There are three classes of instructions (ALU, Ld/St, and Branch) in the instruction set. P1 has a clock rate of 6.0GHz ! The average number of cycles for each instruction class and their frequencies (for a typical program mix) are as follows: Instruction Class P1 CPI Frequency Ld/St?1/3 ALU 1 1/3 structure.com/couree6/21887/qulzze6/242601 midtem: F22 CS tOLO COMPUIEK ARC.HITECORGANIZNILN O1Y, 02 W Riordan 20511, 21871 Branch 21/3 (a) What is the Ld/StCPI required for P1 to achieve an average CPI of 2.0 (rounded to the nearest integer)? (b) What is the mips rating for P1 (rounded to the nearest integer)? (c) If the average Google search takes 30 billion instructions to execute, how long in seconds would P1 as specified above need to do that search (rounded to the nearest integer)? (d) Which one of the Eight Great Ideas could be utilized to dramatically (more than a factor of 10 ) decrease the search time? (e) Which one (most important) of the remaining Great Ideas enabled that Great Idea (your previous answer)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

Computer Organization and Networks Practicals 2021/22 October 9, 2021 Computer Organization and Networks Practicals 2021/22 b68495714b Contents Contents 0 Introduction 3 0.1 Registration . . . . . ....

its a 3 part question the first two pictures is the same question just the other part of the diagram, the next two pictures are each separete 1. [6 points] Consider two different implementations, M1...

4.2 The basic single-cycle MIPS implementation in Figure 4.2 can only implement some instructions. New instructions can be added to an existing Instruction Set Architecture (ISA), but the decision...

Consider two different implementations of the RISC-V instruction set architecture. P1 has a clock rate of 3.0 GHz and CPIs of 1, 2, and 3 for ALU, load/store and branch instructions. P2 has a clock...

8. (10%) Performance Consider two different implementations of the RISC-V instruction set architecture. P1 has a clock rate of 3.0 GHz and CPIs of 1, 2, and 3 for ALU, load/store and branch...

[1] Consider three different processors P1, P2, and P3 executing the same instruction set with the clock rates and CPIs given in the following table. Processor Clock Rate CPI 3 GHz 1.5 P2 2.5 GHz 1.0...

4.3. When processor designers consider a possible improvement to the processor datapath, the decision usually depends on the cost/performance trade-off. Assume we start with datapath shown in the...

Provide a summary technical report with about Pipelined Execution which is also named as Instruction Level Parallelism, addressing mainly the following areas: 1. What is Pipelined Execution and its...

Question: Check you are in charge of the design of both hardware and software for a new (but fairly conventional) workstation which will have its peripherals (for example a disc drive and a printer)...

In this question assume that p and q are atomic formulae. (a) Compare and contrast path formulae and state formulae in temporal logic. [4 marks] (b) Describe and contrast the meanings of F(G p) and...

One mole of an ideal gas at an initial temperature of T K does 6R joules of work adiabatically. If the ratio of specific heats of this gas at constant pressure and at constant volume is 5/3, the...

Calculate the firms cash conversion cycle given annual sales are $660,000 and cost of goods represent 80% of sales. Assume a 365-day year.

What is the permitted disparity for a defined contribution plan with a current base contribution percentage of 6 % ? A ) 1 1 . 7 % B ) 6 . 0 % C ) 1 2 . 0 % D ) 5 . 7 %

Seved Help 14 Wisconsin Snowmobile Corp. is considering a switch to level production Cost efficiencies would occur under level production, and aftertax costs would decline by $31,500, but inventory...

LO6 Identify several concerns about appraisal feedback and ways to make it more effective.

1. What is your overall opinion of the stack ranking system? Do you think this approach serves a purpose in modern organizations?

1. Some managers consider performance management to be a useful tool, while others believe it is a waste of time. It is important for HR professionals to understand current opinions regarding this...