Mount Y$-0024/008$ module to its place. Make the circuit connections as shown in Figure $8\mathrm{.}1\mathrm{.}5.$ Apply

energy to the circuit.

$1$

$-$ DATA signal will be seen in CH$1$ channel of the oscilloscope. Make the DUTY CYCLE ratio of the output signal of DATA oscillator $50\%.$ In this case, the time frame of DATA signal that passes in positive and zero will be equal.

$2$

$-$ Apply a sine wave having a frequency F$=2$KHz$,$ amplitude Vpp$=2,5$Volt from peak to peak to the carrier signal $($Fc$)$ input $.$

$3$

$-$ Adjust P$1$ and P$2$ potentiometers and enable a PSK modulated signal formation at the output terminal of the modulator. What can be said about this signal?

$4$

$-$ Adjust Duty$-$Cycle ratio to $66\%$ from DATA oscillator. In this case, the first two bits of DATA that is made of three bits is $1,$ and its third bit means $0.$

$5$

$-$ Adjust Duty$-$Cycle ratio to $33\%$ from DATA oscillator. In this case, the first bit of DATA, which is made of three bits, is $1,$ and its third bit means $0.$