on designing multiple resistor circuits Instructions: For each circuit presented, you will construct the circuit using power-point shapes (resistors, wires, meters,...). In addition, based on the voltage values, you will calculate the total resistance and the total current for each circuit. The power-point file that you are to work on is in Files. Open it, perform the work, save it, and lastly upload it to the link provided. Refer back to the video in the previous module if you need a start. NOTE: When placing the ammeter in its place, you are measuring the current (coming out of) that would flow back through the battery. 1. Two resistors in series: Construct the circuit on your breadboard for the two-resistor series circuit. Place an ammeter to measure the TOTAL current in the circuit. Measure the voltage across any of the two resistors. Drag the voltmeter to a convenient spot and take two wires to hook it up properly to measure the desired voltage. Place the value of the reading (what it should read ideally) in the space provided on the sheet. Use the wires provided. Save the red for the power input and then use