Question: P 4 Use the virtual Work Principle to compute the horizontal deflection of points C and D and the rotation of the support at A

P4
Use the virtual Work Principle to compute the horizontal deflection of points C and D and the rotation of the support at A. Assume E =200GPa and I=29010mm4.
5lN
P 4 Use the virtual Work Principle to compute the

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

Question 4 ( 2 5 marks - 5 0 minutes ) For the frame shown in Figure 4 , carry out the following analysis: Draw the axial force diagram, shear force diagram, and bending moment diagram for the frame....

Q:

correct Learning Goal: The method of virtual work can be applied to beams and frames. The displacement of a specific point on a beam caused by external loading can be determined using the virtual...

Q:

What's the answer to the questions above? Thank you Notes: (1) Label all your solutions, namely: (a), (b), (e) .... (g) individually for all items. (2) Box the final answers for each. (3) Refer to...

Q:

To use the virtual work method, start by removing the real loads and place a unit load or unit couple moment at the desired location in the direction the displacement or rotation is to be determined....

Q:

Just question 2 please The two - span continuous beam shown below is statically indeterminate ( D S I = 1 ) . A uniform distributed load is applied across both spans, for which an indeterminate...

Q:

Problem 1 Determine the deflection at the left overhang of the beam loaded as shown below using the two methods indicated in the group of your choice. Choose and use only one group. ( No mixing of...

Q:

the tangential rotation. To use the virtual work method, start by removing the real loads and place a unit load or unit couple moment at the desired location in the direction the displacement or...

Q:

The truss shown is subject to two loads P = 5 kN applied at joint A and 2.5 kN applied at joint B. The two applied loads resulted in the internal forces shown. Tension positive (T) and Compression...

Q:

Compute the vertical deflection of point C for the cantilever beam shown in Figure Q3-A. Given I-500106 mm, E-20 GPa. (Use the Complementary Virtual Work Method). [8 Marks] A w=8 kN/m -4 m- A w=3...

Q:

The fram shown has a roller support at A and a pin at D . It carries a uniform load of 1 0 kip / ft along member BC . Assume constant value of EI . E = 2 0 0 0 0 0 MPa I = 1 3 6 x 1 0 ^ 6 mm ^ 4 ....

Q:

In designing a fraction nonconforming chart with center line at p = 0.20 and three-sigma control limits, what is the sample size required to yield a positive lower control limit? What is the value of...

Q:

In Problem find S2 for the indicated initial - state matrix S0, and explain what it represents. S0 = [0 1] Problem refer to the following transition matrix: p- A .8 21

Q:

Under the Revised Model Business Corporation Act, Multiple choice question. as long as the book value of assets exceeds the book value of liabilities after distribution, the company is considered...

Q:

00 10 points Book Print 4-1, 4-3, 4-5, 4-6] PA4-2 (Algo) Assigning Costs Using Traditional System, Assigning Costs Using Activity Proportions (LO of $138,330. Carlise Corp., which manufactures...