pleas help me

I hope to write the complete solution to get the full score

Objective:

Assignment Description: This project involves you to think of a business you are very familiar with its business processes, and do the following:

Tasks: Task 1. Design its process architecture as follow [3 points]: 1. Identify the core, support, and management processes. Organize the processes within appropriate process groups in a process landscape. 2. Identify the value chains for sourcing and renting the equipment

Task 2. Model the as-is business process as follow [4 points]: Using BMPN, model the as-is business process and make sure to show events, activities, message flows, pools, swim lanes and other artifacts where needed.

Note: Use the concept of a Black box where needed.

Task 3. Explain what is happening step by step [3 points]. 1. There should be a detailed description of the model. Name the participants, and explain what is happening, step-by-step. 2. Indicate what triggers n(Starts) the process, explain input and outputs.

Procedure: 1. . Please do your diagramming using a BPMN drawing tool and paste the BPMN Diagram into a Word doc. 2. Please include at the beginning of the submission, the course name, the assignment number, your name(s), and id. 3. Ten percent of the grade is the professional presentation of your results.

Guidelines for the model should be: 1. It needs at least 2 pools, and at least 4 swim lanes (could be 3+1, or 2+2 or more). 2. There should be some communication among the pools. 3. There need to be several activities and gateways among the lanes. 4. The example cannot be taken from any of the articles on our examples in Lecture notes, pervious assignments, or from the book.

this is .

This is a colleague's solution. I want the same method in a different way pleas

If you have any doubt then please do ask in comment anytime!!!!!!!!!!

Solution:

The BPMN diagram is as shown below:

Explanation:

- There are five assembly points in the entire process of manufacturing a flash light.

- In Point 1, the battery is tested and inserted.

- In Point 2, the disk is put on to the reflector and the bulb is tested.

- In Point 3, the Bulb is inserted and Lamp Holder is mounted.

- In Point 4, the Ceiling Ring is put on and the Lens is mounted on the Reflector.

- In Point 5, the Lens is inserted and the body is tightened.

Thank you !!!!!!!!

CZ C) Point 1 1. Test the Battery 2. Insert Battery O Point 2 3. Put the disk onto Reflector 4. Test Bulb Point 3 5. Insert Bulb 6. Mount Lamp holder O Point 4 7. Put on Ring 8. Put Lens on Reflector Point 5 9. Insert Lens 10. Tighten Lamp housing CZ C) Point 1 1. Test the Battery 2. Insert Battery O Point 2 3. Put the disk onto Reflector 4. Test Bulb Point 3 5. Insert Bulb 6. Mount Lamp holder O Point 4 7. Put on Ring 8. Put Lens on Reflector Point 5 9. Insert Lens 10. Tighten Lamp housing