Read the measure phase of the MSD Purchasing case study below and answer the following questions. MSD Purchasing Measure Phase.docx (15 points) Provide an operational definition for each CTQ (i.e., how the team will measure each CTQ and decide if a unit is a defect). 2. (15 points) Create a Gage run chart in Minitab using the Gage R\&R data provided in Table 1, and decide if the measurement system is acceptable to measure functionality. 3. (10 points) Compute the process sigma of the current process for both CTQs using the baseline capability data provided in Table 2. Measure Phase for the MSD Purchasing Case Study After the Define phase of the MSD quality project, the team selected two CTQs: durability (CTQ1) and functionality (CTQ2) (refer to the description of the case study in the previous homework assignment for the definitions and technical specifications for these two CTQs). The team continued to the Measure phase with the following three steps: operationally define each CTQ, perform a Gage R\&R study on each CTQ, and develop a baseline for each CTQ. The data for conducting the above steps are provided in the tables below. More specifically, Table 1 provides the Gage R\&R data for functionality, where 2 inspectors measured 10 boxes and recorded the functionality value, with each inspector conducting 2 counts of measurements for each box. Table 2 provides the baseline capability data recorded during a period of two 8 -hour shifts, where one box is sampled and tested during each hour of each shift and each box has one defect opportunity. Takle? Racoline Canahility )ata