Refer to Table S5.1 - Factors for Computing Control Chart Limits (3 sigma) for this problem Sampling 4 pieces of procition cost wire to be used in computer assembly) every hour for the past 24 hours has produced the following renults R Hour 1 2 3 4 5 6 R 0.80 136 x 3 35 300 3.22 3.49 3.07 2.36 R 0.76 1.18 1.48 131 1.17 0.37 Hour 7 8 9 10 11 12 R 053" 1.13 0.76 3.05 255 3.12 295 283 2.97 Hour 13 14 15 16 17 18 x 3:01" 293 3.02 284 2.96 274 Hour 19 20 2 22 23 24 x 451 2.99 2.65 3.38 2.94 274 161 104 1.13 0.46 163 0.97 128 1.17 0.55 138 129 0.40 Based on the sampling done, the controllimits for 3-machart are fround all intermediate calculations to three decine ploce before proceeding with further coloulation) Upper Control Limit (UCL) - inches (round your sponse to three decino plooma). Based on the sampling done, the control limits for 3-sigma x chart are fround all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL ) = inches (round your response to three decimal places). Lower Control Limit (LCL) - inches (round your response to three decimal places). Based on the x-chart, the wire cutting process has been The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCLR) - inches (round your response to three decimal places). Lower Control Limit (LCLR) - inches (round your response to three decimal places) Based on the R-chart, the wire cutting process has been