Refer to Table S6.1. Eastors for Computing Control Chart Limits (3.sigma) for this problem Twelve samples, each containing five parts, were taken from a process that produces steel rods at Emmanual Kodzi's factory, The length of each rod in the samples vas determined. The results were tabulated and sample means and ranges were computed. The results were: Sample 1 2 3 4 5 6 Sample Mean (in.) 11.302 11.300 11.293 11.308 11.295 11.299 Rango (in.) 0.033 0.041 0.034 0.051 0.031 0.036 Sample Sample Mean (In.) Range (in.) 7 11.301 0.041 8 11.305 0.034 9 11.293 0.027 10 11.301 0.029 11 11.303 0.039 12 11.306 0.047 For the given data, the x = inches (round your response to four decimal places). Based on the sampling done, the control limits for 3-sigma chart are: Upper Control Limit (UCLz) inches (round your response to four decimal places). Lower Control Limit (LCL) - inches (round your response to four decimal places). Based on the x-chart, is one or more samples beyond the contro limits ? For the given data, the R-inches (round your response to four decimal places) The control limits for the 3-sigmo R.chart are: Upper Control Limit (UCLR) - inches (round your response to four decimal placos), Rodzis factory. The length Definition Upper Range, Lower Range, Sample Size, n 2 3 DA D3 4 5 6 7 8 9 10 12 Mean Factor, A2 1.880 1.023 0.729 0.577 0.483 0.419 0.373 0.337 0.308 0.266 3.268 2.574 2.282 2.115 2.004 1.924 1.864 1.816 1.777 1.716 0 0 0 0 0 0.076 0.136 0.184 0.223 0.284 Print Done 7