Refer to Table S6.1 - Factors for Computing Control Chart Limits ( 3 sjgma) for this problem. Sampling 4 pieces of precision-cut wire (to be used in computer assembly) every hour for the past 24 hours has produced the following rosuls. Based on the sampling done, the control limits for 3 -sigma x chart are (round all intermediate calculations to three decimal places before proceeding with further calculations). Based on the sampling done, the control limits for 3-aigma x chart are fround all intermeclate calculations to three decimal Upper Control Uimt (UCL- )=3.7877 inches (round your responoe to three decimal plasea). Lower Control Limt (LCL-) = 2.2853 inches (round your reoponse to three decimal places). Based on the x-chart. the wire cutting process has been OUT OF CONTROL The control linits for the 3-aigma R-chart are fround all intermeciate calculations to thee decimal pil Upoer Control Limit (UCLR)=2.350 inches (round your response to thee decimal placea). Lower Control Lmt (LCLR)=0.000 ) inches (round your response to thee owcimal places). Eased on the R-chart, the wire cutting process has been