Refer to Table S6,1 - Factors for Computing Control Chart Limits (3 sigma) for this problem. Sampling 4 pieces of precision-cut wire to be used in computer assembly) every hour for the past 24 hours has produced the following results: Hour R Hour 1 2 3 4 5 6 X 3.35" 3.00 3.12 3.49 3.07 2.96 R 0.71" 1.23 1.38 1.26 1.12 0.42 Hour 7 8 9 10 11 12 x 3.15 2.65 3.12 2.95 2.73 2.87 0.58 1.18 0.66 1.28 1.12 0.40 Hour 13 14 15 16 17 18 x 3.21" 2.73 3.02 2.94 2.96 2.64 R 0.80* 1.31 1.01 0.45 1.48 1.34 19 20 21 22 23 24 X 3.41" 2.79 2.65 3.28 3.04 2.64 R 1.56" 1.04 1.13 0.41 1.63 1.02 Based on the sampling done, the control limits for 3-sigma x chart are (round all intermediate calculations to three decimal places before Based on the sampling done, the control limits for 3-sigma x chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL) - inches (round your response to three decimal places). Lower Control Limit (LCL:) - inches (round your response to three decimal places). = Based on the X-chart, the wire cutting process has been The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCLR)-inches (round your response to three decimal places) The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCLR) - inches (round your response to three decimal places). Lower Control Limit (LCLR) - inches (round your response to three decimal places). Based on the R-chart, the wire cutting process has been