revise and fix grammatical error incorporate bullet points when needed

ADJUSTING THE SCREEN

TV Set

Now, turn down the TV volumn all the way, turn ON your TV, then, you can turn ON the computer by plug the power cord into the jack, and watch for the screen. If you have followed each step correctly, three things will happen when you turn ON the computer:

The power lamp should light, the computers speaker should beep! and a blinking square called the cursor should appear on the bottom left corner of the screen.

If the power lamp do light and the specker do Beep but you dont see the blinding cursor on the screen, dont be worry. You just want to tune your TV. First, check whether your TV is set to channel 3 (or channel 2); if the channel are correct, tune the fine tuning knob of your TV set until you get a square cursor.

If after these steps, your screen still dont display correctly, you can press the ENTER key and hold it down while press the RESET key on your computer or you can simply turn OFF the computer then turn back ON again. That will probably do the trick.